Automatic stereo library Difficulties and treatment methods to make subgrade soft
The concrete roadbed that has not been compacted cannot bear its own weight, causing the server to drop, causing imbalance. The subgrade must be compacted and the whole body must be flat. Because the glass support is not fixed properly. It is easy to move when grinding large glass, resulting in horizontal difference. We just need to calibrate the stand. Long term use of the equipment only replaces a small part of the conveying chain. The new and old use of lattice glue, and the height difference results in grinding out the size of the glass head. All plaids must be removed, otherwise the entire conveyor chain must be removed.
Automatic 3D library, drive chain level is uneven. There is no parallel line between the front and rear pins of the conveyor chain at one end of the glass and the conveyor chain at the other end of the glass. Z First adjust the height of the guide rail to enter the glass end (arrange the screw ball screw to complete according to the lower stroke of the adjustment guide rail), so that the 2500 long glass in polishing is always attached to the guide rail on the conveyor chain. (When the glass enters the pressing plate for 40 cm, pay attention to two things: the glass on the lower transmission chain and the glass on the right transmission chain of the equipment are connected with the transmission chain.) If the lower pressing plate glass breaks away from the transmission chain and turns over, if the glass end of the right transmission chain turns over (turns over), the correct guide rail must be raised to the level of the progress screw. The equipment adjusts the left chain of the conveyor horizontally, with the same basic principle and logical reasoning. The head and tail parts or the middle part cannot be polished, the head and tail parts cannot be polished, and the rear glass sprocket cannot be offset, causing the glass to move forward. First, remove the covers on both sides, take out the alignment height and angle of view of the front two sprocket chains of the glass, and take the two sprocket chains on the reducer as the standard.
